Home /Products/Iceless Cold Therapy /Heat and Cold Therapy Machine
hot and cold therapy machine
Iceless Cold Therapy
Cold + Heat + Compression
CE + FDA Cleared

BEST FOR CLINICS

Heat and Cold Therapy System,Hot and Cold Therapy Machine

Our flagship iceless cold therapy machine. Semiconductor technology (Peltier Effect) delivers precise cold therapy down to 4°C, heat therapy up to 45°C, and integrated pneumatic compression — all from a single device. No ice to buy, no melted ice to top up, no hot packs to restock — just add water once and the semiconductor unit does the rest. Set the exact temperature on the digital display, and treat. Designed for physical therapy clinics, rehabilitation centers, and distributors who want the most advanced product in their cold therapy lineup.

❄️
No Ice Needed
Semiconductor cooling
🔥
Cold + Heat
4°C – 45°C range
💨
+ Compression
Integrated pneumatic
🎯
Precise Control
Digital display, exact °C
Quick Specifications
Part CodeA02-C-032
TechnologySemiconductor (Peltier Effect)
Temperature Range4°C – 45°C
Ice / RefrigerantNo ice — add water once
CompressionIntermittent Pneumatic
Available Wraps9 options
CE Certified
FDA 510(k)
Quiet Operation
OEM/ODM Available
——3 Therapies, 1 System

Cold, Heat, and Compression — All in One Device

Semiconductor technology lets this single machine deliver three distinct treatment modalities, replacing what would otherwise require an ice machine, a hot pack warmer, and a separate compression unit.

❄️

Cold Therapy

4°C

Reduce swelling, numb pain, and control inflammation. Precise temperature down to 4°C without any ice.

✓ Post-surgery recovery
✓ Acute injury management
✓ Post-exercise inflammation
🔥

Heat Therapy

45°C

Relax stiff joints, increase blood flow, and relieve chronic muscle pain. Controllable heat up to 45°C.

✓ Chronic pain & arthritis
✓ Joint stiffness & mobility
✓ Pre-exercise warm-up
💨

Compression Therapy

Pneumatic

Integrated air compression reduces edema and improves lymphatic drainage — enhances both cold and heat modes.

✓ Edema & swelling reduction
✓ Lymphatic drainage support
✓ Enhanced treatment penetration
——Key Features

Why Clinics Choose the Iceless Approach

No Ice — Just Add Water Once

Semiconductor technology (the Peltier Effect) moves heat electrically instead of relying on melting ice or a compressor and refrigerant gas. That means no daily ice runs, no refilling a reservoir between patients, and no puddles on the treatment table.

✓ Ready for the next patient immediately
✓ No plumbing or drain access required
✓ Lower daily operating cost than ice-based machines
Heat and Cold Therapy System
hot and cold therapy machine 1

Precise Digital Temperature Control

Set the exact temperature you want on the built-in digital display, rather than guessing with ice that starts cold and gradually warms. The system holds that temperature steady for the entire session, giving every patient a consistent, repeatable treatment.

✓ Exact temperature from 4°C to 45°C
✓ Consistent treatment across every session
✓ Easy to document exact temps in patient records

Built-In Safety for Unsupervised Sessions

High and low temperature protection, automatic drainage, automatic shutdown at the end of a session, and multiple sensor detections mean the device can run safely while your staff attends to other patients.

✓ High/low temperature protection
✓ Automatic shutdown when session ends
✓ Multiple sensors monitor pad connection & temp
iceless cold therapy machine

Iceless vs. Traditional Ice Machines

What changes when you remove the ice from the equation.

Factor H&C System Ice Water Machines
Daily Ice Purchases None Required daily
Heat Therapy Yes, up to 45°C Not available
Temperature Precision Exact digital setting Gradually warms
Between-Patient Turnaround Immediate Requires refill
Water Handling Fill once, sealed loop Refill ice + water
Best For High-volume clinics Budget-conscious buyers
Specifications

Technical Specifications

Parameter Details
Product Name Heat & Cold Therapy System
Part Code A02-P-001
Cooling/Heating Method Semiconductor (Peltier Effect) — no ice, no refrigerant
Temperature Range 4°C – 45°C, digitally adjustable
Time to Reach 5°C ~18 minutes (30°C ambient room)
Compression Integrated pneumatic compression
Display Digital LED display — exact temperature & session time
Safety Protections High/low temp protection, auto drainage, auto shutdown, multi-sensor detection
Noise Level Low noise — suitable for treatment room environment
Power Input 100–240V AC, 50/60Hz (custom voltage available for OEM)
Ice / Refrigerant Required No ice, no refrigerant — add water once (recirculates in sealed loop)
Package Includes Main unit, treatment pad/wrap, connection hose, power cable, user manual
OEM/ODM Available — custom logo, color, packaging, voltage
Certifications CE, FDA 510(k), ISO 13485:2016, MDSAP

Need a different battery configuration or custom branding? Contact our sales team to discuss your requirements.

Accessories

9 Wraps for Every Body Part

Each wrap includes a removable gel pack and is anatomically designed for the target body area.

HC-system shoulder wrap
Shoulder Wrap

A02-C-032-B

HC-system thigh wrap
Thigh Wrap

A02-C-032-C

HC-system universal wrap
Knee Wrap

A02-C-032-T

HC-system hip wrap
Hip Wrap

A02-P-001-E2

HC-system hand wrap

Hand/wrist Wrap

A02-C-021

HC-system Elbow wrap
Elbow Wrap

A02-P-001-F

HC-system back wrap
Back Wrap

A02-P-001-E

HC-system ankle wrap
Ankle Wrap

A02-P-001-A1

How to Use

Quick Setup in 4 Steps

1
Fill the Water Tank Once
Add water to the tank up to the fill line — a one-time setup, no ice required. The water recirculates in a sealed loop as the heat-transfer medium, so you won’t need to keep adding ice or topping up water between patients like a traditional ice water machine.
2
Connect the Pad & Choose Cold or Heat
Attach the treatment pad or wrap to the main unit with the connection hose and position it over the treatment area. Power on and select your mode on the digital display: cold therapy down to 4°C for swelling and acute injuries, or heat therapy up to 45°C for stiff joints and chronic pain.
3
Set Temperature, Compression & Timer
Set the exact temperature on the digital display — the system reaches 5°C in about 18 minutes and holds it steady. Turn on the integrated pneumatic compression to enhance the treatment, then set the session timer (typically 15–20 minutes).
4
Treat — Then Ready for the Next Patient
The system runs the session automatically and shuts off when the timer ends, with high/low temperature protection throughout. When done, simply change the pad and set the next temperature — the water stays in the sealed loop, so there’s no ice to refill and the device is ready for the next patient right away.
Applications

Where the Heat & Cold Therapy System Fits

Who Uses This System

🏥

Physical Therapy Clinics

Primary treatment station for daily patient sessions — cold, heat, or compression as the protocol requires.

🏠

Rehabilitation Centers

Supports every recovery stage — cold in the acute phase, heat once swelling subsides, compression throughout.

🏋️

Elite Training Rooms

Professional teams and training centers use it as the premium fixed station alongside portable sideline devices.

🏷️

Distributors & OEM Brands

Our flagship product for building a premium private-label cold therapy line with full OEM branding.

FAQ

Frequently Asked Questions

The Heat & Cold Therapy System uses semiconductor technology, also known as the Peltier Effect, to move heat directly using electricity rather than ice or refrigerant gas. This lets the device produce both cold (down to 4°C) and heat (up to 45°C) from the same solid-state component, with no ice, no water reservoir to refill, and no compressor or refrigerant lines to maintain.

In a 30°C room, the system reaches 5°C in approximately 18 minutes. Heat therapy reaches 45°C faster than cold reaches its minimum. Once the target temperature is achieved, the system holds it precisely for the entire session, unlike ice which gradually warms.

The system includes high temperature protection, low temperature protection, automatic drainage, automatic shutdown at the end of a session, and multiple sensor detections to monitor temperature and pad connection throughout treatment.

Yes. Because there is no ice to refill or melt, the system is ready for the next patient immediately after a session ends. A single unit can support 15-20+ patient sessions per day in a busy clinic; we recommend 2-3 units for high-volume practices.

The system includes integrated pneumatic compression that works alongside both cold and heat modes. During cold therapy, compression helps push cold deeper into tissue and limits fluid build-up. During heat therapy, compression supports circulation for faster nutrient delivery to the treatment area.

Yes. Full OEM customization is available, including logo, housing color, and packaging. This is popular with multi-location physical therapy chains, rehabilitation centers, and distributors building a private label cold therapy brand. MOQ starts from 50 units.

Both systems use semiconductor technology to deliver iceless cold, heat, and compression therapy. The CryoPush system is available at factory-direct pricing, well below Game Ready retail, and supports full OEM branding along with the same CE and FDA certifications. Contact us for a detailed side-by-side comparison.

Clinical References

Evidence-Based Cold Compression Therapy

  1. Dahl J, Li J, Bring DK-I, Renström P, Ackerman PW. Intermittent pneumatic compression enhances neurovascular ingrowth and tissue proliferation during connective tissue healing. Journal of Orthopaedic Research. 2007;25:1185-1192. PubMed →
  2. Sabiston KB, et al. The effects of intermittent compression and cold on reducing edema in postacute ankle sprains. Journal of Athletic Training. 1992;27(2):140. PubMed →
  3. Capps SG, Mayberry B. Cryotherapy and Intermittent Pneumatic Compression for Soft Tissue Trauma. Athletic Training and Sports Health Care. 2009. Journal →
  4. Hubbard TJ, Denegar CR. Does cryotherapy improve outcomes with soft tissue injury? Journal of Athletic Training. 2004;39(3):278-279. PubMed →
  5. Schaser K-D, et al. Local cooling restores microcirculatory hemodynamics after closed soft-tissue trauma in rats. Journal of Trauma. 2006;61(3):642-649. PubMed →
  6. Hochberg J. A Randomized Prospective Study to Assess the Efficacy of Two Cold Therapy Treatments Following Carpal Tunnel Release. Journal of Hand Therapy. 2001. PubMed →
  7. Bleakley CM, McDonough SM, MacAuley DC. Cryotherapy for acute ankle sprains: a randomised controlled study of two different icing protocols. British Journal of Sports Medicine. 2006;40(8):700-705. PubMed →
  8. Moussa MK, Lefevre N, Valentin E, et al. Dynamic intermittent compression cryotherapy results in faster pain reduction. Orthopaedics & Traumatology: Surgery & Research. 2020. PubMed →
  9. Capps SG, Mayberry B. Cold and compression in the management of musculoskeletal injuries and orthopedic operative procedures: a narrative review. Open Access Journal of Sports Medicine. 2009;3:59-74. PMC Full Text →
  10. Bleakley C, McDonough S, MacAuley D. The use of ice in the treatment of acute soft-tissue injury. American Journal of Sports Medicine. 2004;32(1):251-261. PubMed →

These references support the general efficacy of cold compression therapy and intermittent pneumatic compression. Individual results may vary. CryoPush products are designed based on these clinically validated principles.

You May Also Like

Related Cold Therapy Products

cold therapy system3-600

Cold Therapy System Ⅲ

Ice water,Best-selling entry unit

View Product →

cold compression wrap pro 600

Cold Compression Wrap Pro

Dual port, gel cold therapy

View Product →

CryoPush Pulse Cold Compression Therapy System front view with digital control panel and ice water cooler

Pulse Cold Compression

Ice water + intermittent, 9 presets

View Product →

cold compression wrap 2.0 600

Cold Compression Wrap 2.0

Manual pump, gel pack, 11 wraps

View Product →

Upgrade to Iceless Cold & Heat Therapy

Factory-direct pricing for clinics and distributors. CE & FDA certified, OEM branding available